Right aileron and flaps (leading edge)

After a brief hiatus for summer vacations, plus trying to get other stuff done around the house, we finally got back to working on the ailerons and flaps.  Previously, we had worked on the fiberglass leading edge for the left-side aileron and flaps.  Now we shifted to the same tasks, but on the right-side aileron and flaps.

This is messy work because we are carefully cutting, trimming, and sanding fiberglass.  The picture shows Michael test-fitting the fiberglass leading edge piece onto the aileron, and you can see that gloves and a breathing filter are needed to keep all the fine fiberglass dust from becoming an irritant.   The trimming and fitting takes a bit of time because we have to be careful so that it fits nicely at each rib, and don't want to mess up and trim off too much.  Hours: 2.5

Michael test fitting the fiberglass leading edge onto the aileron